|
|
Post by yammies on Feb 27, 2012 20:18:23 GMT 12
Has anyone got any chevette brake booster clevises lying around that they are willing to part with? I need at least one, preferrably two.
|
|
|
|
Post by crazytim on Feb 28, 2012 8:38:23 GMT 12
you may want to dumb it down a little... wtf is a clevis? I thought it was cluthead's best mate, don't think this is what you mean though...
|
|
|
|
Post by gordo on Feb 28, 2012 18:26:39 GMT 12
May have a couple, but finding them...
If I were you, I'd just measure up what I needed and buy them from a local hardware/fastner shop. Should be only a couple of bucks each.
|
|
|
|
Post by yammies on Feb 28, 2012 20:37:20 GMT 12
the clevis is the bit on the end of the brake booster rod that attaches to the brake pedal. The bit that the clevis pin goes through (thats where the pin got it's name from)
I'll see if bay engineers here in palmy have them but most of them tend to have too small a thread up the back of them for what i need.
|
|
|
|
Post by crazytim on Feb 29, 2012 13:35:06 GMT 12
will check my clevis box...
|
|
|
|
Post by gordo on Mar 1, 2012 3:11:39 GMT 12
Me bad, I thought it was the pin you needed.
In a different application, I had to fabricate some - I used a couple of pieces of hex' rod drilled and tapped then welded a couple of pieces of 3mmx20mm mild steel on the sides before drilling the pin hole and cleaning it up.
I've also seen them made by cutting/milling a slot instead.
|
|
|
|
Post by crazytim on Mar 1, 2012 12:46:44 GMT 12
I got none, only whats on my spare boosters would rather not take off as I will no doubt end up needing them...
|
|
|
|
Post by yammies on Mar 3, 2012 10:28:23 GMT 12
sweet as.. I'm getting some from RS components. They aren't exactly what i wanted but will have to do. I'm pretty sure the clevis pin on the chevettes are 8mm with a 10mmx1.5 thread on the clevis. The ones i'm getting are 10mm pins...
|
|
